Skip to content

Drip tube and weepers

Garden beds are often watered by 13 mm drip tube or soaker (weeper) hose rather than sprinklers. Groundsman can list these by the metre, or you can draw where they run on the map. It then works out the flow and how much of the bed gets wet.

Turn on List each zone’s sprinkler heads under Sprinklers in Settings. Drip tube and hose are added in the same list as sprinkler heads. See sprinkler heads.

  1. On the Zones tab, open the bed’s zone under Timers.
  2. Under Sprinklers, press Choose by photo and filter by Drip, soaker and micro, or pick from Brand… and Model….
  3. Type how many metres and press Add.

For drip tube, Groundsman shows how many drippers that is, how far apart, and the total litres a minute.

For soaker or weeper hose, makers don’t publish a flow, so type the whole hose’s L/min. If the zone has a flow meter and has run, press Use the last run’s figure instead.

Drawing the runs gives the length for you and shows coverage. The map needs its scale set first. See map scale.

  1. Press Draw on map next to the tube.
  2. Click along where the tube runs, corner by corner.
  3. Use Undo point to take back a click.
  4. Press Finish this run to start another, such as the next row.
  5. Press Done when you’re finished.

The length now comes from the map. Clear runs takes them off so you can type a length again.

To place a run’s corners by tape measurements, press 📏 By distance. See place by distance.

On the map, the tube or hose wets a strip either side of each run. Groundsman says about how much of the bed that covers. Plants further away rely on their roots reaching it.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au