How to fix dry patches in your lawn
Most dry patches come from uneven watering, not too little watering. A sprinkler that doesn’t reach, a blocked nozzle or soil that sheds water leaves one spot short while the rest of the lawn is fine. Turning up the whole zone wastes water; finding the cause and fixing that spot works better.
Work out the cause
Section titled “Work out the cause”Look at the shape and place of the patch. It usually points to the cause.
- Between sprinklers, or at the edge of a zone: a coverage gap. Sprinklers should throw all the way to the next head. Patches midway between heads, or in corners, mean they don’t.
- Around one head: a blocked or wrong nozzle, a sunken head or one turned the wrong way.
- Beside paths, driveways and north-facing walls: reflected heat dries these strips much faster. They often need more water than the middle of the lawn.
- Under or near trees: roots take the water, and the canopy blocks sprinklers.
- Water beads or runs off: water-repellent soil. This is common on Adelaide’s sandy coastal soils and under old lawns, where a waxy coating stops water soaking in.
- Soil is rock hard: compaction from foot traffic or cars. Water runs off before it gets in, and clay makes it worse.
- Grass lifts like carpet: lawn grubs or armyworm eating the roots. Check by pulling back the turf at the edge of the patch.
- Small round patches with a green ring: often dog urine.
Fixes that work
Section titled “Fixes that work”Coverage gaps
Section titled “Coverage gaps”Clean or replace blocked nozzles, raise sunken heads and turn heads back to face the lawn. If heads don’t reach, a nozzle with a longer throw or an extra head may be needed. A catch-cup test shows which parts of the zone get the least.
Water-repellent soil
Section titled “Water-repellent soil”Apply a soil wetting agent, ideally in spring before the heat, and water it in. Repeat as the label suggests. Wetting agents help water soak in rather than run off or sit on the surface.
Compacted or clay soil
Section titled “Compacted or clay soil”Core aerate in spring or early autumn while the grass is growing, then top dress. On clay, use cycle and soak (several shorter runs with a gap) so water soaks in rather than running off.
Hot edges
Section titled “Hot edges”Hand water these strips in a heatwave, or give the zone a little more and accept the middle gets slightly more than it needs.
With Groundsman
Section titled “With Groundsman”Groundsman can show where the water goes, and adds the jobs that fix the soil.
- Run a catch-cup test under the zone on Home. It gives the zone’s evenness (the driest quarter against the average). A low figure confirms a coverage problem.
- If you list your sprinkler heads (Settings > Sprinklers) and place them on the Zones map, dry spots show as red dots. Tap Suggest better settings to try other nozzles, arcs and throws, and Try moving heads too if heads are in the wrong place. Use these applies them, and can be undone.
- Check Right amount? on the Watering tab (under Health check > Open). It compares each zone’s week with this month’s need for Adelaide and offers to raise or cut it, or split runs into rounds for clay. Its fixes also show under Needs you on the Home tab.
- On the Garden tab, add a job from Add a job: Wetting agent for water-repellent soil, Aerate / core for compaction, or Grub / insect control if you’ve found grubs.
- If you have a soil sensor, put it in the zone and watch how quickly the soil dries after a run.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
