How to fix low water pressure in a watering zone
When a zone gets less water than it used to, the cause is almost always something restricting the flow: a tap not fully on, a blocked filter in the tap timer, a kinked hose or too many zones sharing one tap. Start at the tap and work outwards along the pipe.
Signs of low flow
Section titled “Signs of low flow”- Sprinklers don’t pop up fully, or spray short of the next head.
- Rotors turn slowly or stall.
- Drippers at the far end of the line barely wet the soil.
- Plants or lawn at the end of a zone dry out first.
- The flow meter shows fewer litres a minute than the zone normally uses.
Check these, in order
Section titled “Check these, in order”1. The tap
Section titled “1. The tap”Someone uses the garden tap for the hose and turns it back on only halfway. Open it fully. If the tap is old and stiff, the washer may be half-closing it.
2. The timer’s inlet filter
Section titled “2. The timer’s inlet filter”Tap timers have a small mesh filter or washer where they screw onto the tap. Grit, rust and calcium build up on it, especially on older pipes. Unscrew the timer, rinse the filter under running water and refit it. This fixes more low-flow problems than anything else.
3. Hoses and pipes
Section titled “3. Hoses and pipes”- A hose kinked under a pot, squashed by a wheelie bin or chewed by the dog.
- Poly pipe crushed under new paving or pinched by a tree root.
- A fitting that has partly pulled apart: you lose pressure and get a wet patch.
4. Filters and nozzles further along
Section titled “4. Filters and nozzles further along”Drip systems often have a separate filter near the tap; clean it. Blocked sprinkler nozzles have their own small filter screens under the nozzle that can be rinsed out.
5. Pressure
Section titled “5. Pressure”Mains pressure can drop on hot summer mornings when the whole street is watering. If every zone is weaker at peak times, a slightly earlier start may help. A pressure gauge on the tap gives you a reading to compare later.
6. Zones running together
Section titled “6. Zones running together”Two zones on the same tap at the same time share its flow, so each gets less. Run them one after the other instead.
With Groundsman
Section titled “With Groundsman”If your timers have flow meters, Groundsman learns each zone’s usual litres a minute and flags a drop.
- Look at the top of the Home tab for Less water than usual. It appears when a run’s flow is well under the zone’s normal. Watering carries on; it’s a flag, not a pause.
- If the meter counted nothing at all, you’ll see No water came out. Check the tap is on and the hose to the timer isn’t disconnected or blocked.
- Tap History on the alert to compare the run with earlier ones. A slow fall over weeks points to a filter clogging up; a sudden drop points to a closed tap or a kink.
- Fix the cause, then run the zone for at least 2 minutes with Test timers or a quick run from Home to check the flow is back.
- Tap I’ve checked it: clear on the alert.
- To stop zones on one tap sharing water, open the Watering tab, press Open on the Health check line and set Running together to One per tap.
If you’ve listed your sprinkler heads, the zone also says how many litres a minute they should use and what the meter measured last run. More than a quarter out means a leak, a blocked or missing nozzle or low pressure.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
