Skip to content

How to test your sprinkler zones

Run each zone on its own for a minute or two and walk it while it runs. You’re looking for heads that don’t pop up, sprays that hit the fence or path, wet spots that shouldn’t be there and drippers that have stopped. Do it every spring, before the first hot spell, and after any digging in the garden.

  • Early spring (September or October): after winter, when many Adelaide systems have barely run for months. Ants, grit and grass all get into heads over winter.
  • After work in the garden: new paving, a new bed or a trench can crush a pipe or bury a head.
  • When something looks off: a brown patch, a soggy patch or a jump in water use.

Walk each zone with the water on and look at every head.

  • Pop-up: it should rise fully and drop back when the water stops. A stuck head usually has grit in it; pull the riser up and flush it.
  • Height: heads sink over time and grass grows around them. Trim the grass back and raise a sunken head so it clears the turf.
  • Pattern: the spray should reach the next head (head-to-head coverage). A short or misty spray suggests a part-blocked nozzle or low pressure.
  • Direction: quarter and half heads get knocked by mowers. Turn them back so they water lawn, not paths.
  • Leaks: water bubbling around the base, or a gusher where a nozzle used to be.

Drip lines hide their problems under mulch.

  • Pull back the mulch in a few places and check each dripper is wetting.
  • Look for a flooded spot (a split or a dripper that has popped off) and dry plants at the end of a run (too little pressure, or a blockage).
  • Flush the line: open the end plug, run the zone until the water runs clear, then close it again.
  • Clean the filter at the tap if there is one.

A day after a normal run, push a long screwdriver into the lawn. It should slide in without much effort to at least 10 to 15 cm. If it stops short, the zone isn’t watering deeply enough, or the soil is too hard or water-repellent to take it in.

Groundsman lets you run each zone from your phone while you stand in the garden.

  1. On the Home tab, go to Zones.
  2. Tap Test 1 min on a zone and walk it while it runs. The map lights up the zone that’s running.
  3. For longer checks, tap Test timers. It lists every outlet with On, Turn off, 1, 2 or 5 minutes or any number of minutes, plus each timer’s battery and countdown. Stop everything is at the top if you need it.
  4. Note low batteries on the Test timers page and replace them now rather than in a heatwave.
  5. To measure how much water a sprinkler zone puts down, use the catch-cup test under the zone on Home. It gives the zone’s mm an hour and how even it is, which makes run times accurate. Drip zones don’t have this test.
  6. If you’ve mapped your sprinkler heads, compare what you see with the map: dry spots show as red dots and the zone shows how much water lands off the lawn or bed.

Test runs are manual runs, so they always water as set, whatever the rain or soil sensor says, and they show in History like any other run.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au