Skip to content

How to mix and apply

Any job with a product has a How to mix and apply button. It turns the label rate into amounts for your lawn and your sprayer, with the steps before and after.

  • On the Today checklist: open the job.
  • On the Garden tab: under the job in the list.
  • In the Next week… panel when you move a job.
  • The area: the job’s zones and their total m². If a zone has no area yet, it says which.
  • A product table: each product’s rate Per 100 m² and the amount for Your lawn.
  • Water volume: for sprays, how much water to mix it in.
  • Your sprayer: buttons for common sizes, or type Other (0.5 to 100 L). The steps then say how many tank fills you need and how much product goes in each.
  • Mix and apply: the steps. For granular products, how to spread them evenly.
  • Before and after: water-in run times for each zone, how long to keep it dry, mowing gaps, and the temperature limit.
  1. Open the job and press How to mix and apply.
  2. If you’re spraying, tap your sprayer’s size. Groundsman remembers it.
  3. Measure out the amounts shown and follow the steps.
  4. Press Close, then Done on the job. Groundsman runs any watering in for you. See after-care.

Your sprayer size is also in Settings under Products and plan, as Sprayer size.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au