How to water clay soil without runoff (cycle and soak)
Clay soil takes in water slowly, often only about 5 mm an hour once the surface is wet, while most sprinklers put water down faster than that. The fix is to water in two or more short rounds with a soak of 30 to 60 minutes between them, so each round sinks in before the next.
Why clay runs off
Section titled “Why clay runs off”Many Adelaide suburbs sit on heavy clay. Clay holds plenty of water once it’s in, but its fine particles let water in slowly. When a sprinkler delivers 15 or 30 mm an hour onto soil that can absorb 5, the extra sits on the surface and runs downhill onto paths, driveways and the gutter.
Dry clay makes it worse: it shrinks and cracks in summer, so water can race down cracks in one spot and run off the hard crust everywhere else. Slopes and compacted lawns (where people walk or cars park) are the worst.
Signs your lawn has a runoff problem:
- water on the footpath or kerb partway through a run;
- puddles in low spots while high spots stay dry;
- a lawn that looks dry a day after a long watering;
- a screwdriver that won’t go more than a few centimetres deep.
Cycle and soak
Section titled “Cycle and soak”Instead of one 40-minute run, do two 20-minute rounds with a 45-minute break, or three shorter ones. The total water is the same, but the soil gets time to take each round in.
To set it up by hand:
- Run the zone and watch. Note how many minutes until water starts to pool or run off. That’s the most one round can be.
- Divide your total run time into rounds no longer than that.
- Leave 30 minutes between rounds on loam and up to an hour on clay.
- With several zones, water the other zones during each zone’s soak so the whole cycle doesn’t take all morning.
Help clay take water in
Section titled “Help clay take water in”- Core aerate compacted lawns in spring or early summer, when warm-season grass is growing strongly. The holes let water and air in.
- Top dress with sandy loam after coring to fill the holes with something that drains.
- Gypsum can help some sodic clays (the kind that goes sticky and sets hard). It does nothing for every clay, so a soil test is worth doing first.
- Wetting agent helps where the surface has gone water-repellent.
- Don’t water little and often. It keeps roots in the top few centimetres, where clay bakes hardest.
With Groundsman
Section titled “With Groundsman”Groundsman can split watering into rounds for you, sized to your soil.
- In Settings, set Soil to clay. It sets how much each round can put down and how long the soak is.
- On the Watering tab, press + New program and choose Cycle and soak. Pick your zones and check the suggested rounds and soak.
- For an existing program, open it and set cycles (repeat 1 to 6 rounds) and the soak between them.
- When a zone’s runs are too long for your soil, Needs you on Home offers a one-tap Split into rounds. Right amount?, in the Health check on the Watering tab, offers it too.
While one zone soaks, Groundsman waters the program’s other zones, and only adds a pause when their turns are shorter than the soak. Deep and infrequent and Soil water balance programs also split into rounds when the depth is too much for one go.
On the Garden tab, an Aerate / core job or a Wetting agent job can go on your calendar for the right month.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
