How to lay out drip tube in a garden bed
Lay 13 mm drip tube in parallel rows across the bed, close enough that the wet zones from each row meet, and finish each run with a flushable end. Space the rows closer on sandy soil and wider on clay, run a loop around trees and larger shrubs, and cover it all with mulch. Drip puts water at the roots, wastes little to wind or evaporation, and suits roses and fruit trees that dislike wet leaves.
What you need
Section titled “What you need”- 13 mm drip tube with inline drippers (commonly 2 L/h every 30 cm).
- 13 mm poly pipe to bring water from the tap to the bed.
- A filter and a pressure reducer at the tap. Drippers block with grit and most need lower pressure than mains.
- Joiners, elbows and tees, end plugs or flush valves, and hold-down stakes.
Plan the rows
Section titled “Plan the rows”Water spreads differently in different soils, and Adelaide has both extremes.
- Clay: water spreads sideways a long way. Rows around 40 to 50 cm apart usually meet.
- Loam: around 30 to 40 cm apart.
- Sand (coastal suburbs): water drops straight down. Rows around 30 cm apart or closer.
Run rows the long way across the bed to save on fittings. Keep the first and last rows about 10 to 15 cm in from the edges so water stays in the bed.
Run lengths
Section titled “Run lengths”Long runs lose pressure, so the far drippers give less. Check the maker’s maximum run length. If the bed is large, feed it from the middle with a tee so water travels both ways, or connect the far ends to make a loop.
Trees and big shrubs
Section titled “Trees and big shrubs”A single row past a tree’s trunk isn’t enough. Run a ring of tube around it near the edge of the canopy (the drip line), where the feeder roots are, and widen the ring as the tree grows.
Lay it
Section titled “Lay it”- Water the bed and weed it.
- Roll out the tube in the sun for an hour so it softens and lies flat.
- Lay and pin the rows with stakes every metre or so.
- Flush the lines before fitting the end plugs.
- Turn it on and check every row wets.
- Cover with 5 to 7 cm of mulch. It protects the tube from the sun and slows evaporation.
Drippers are often exempt from watering time rules, so they can run at cooler hours outside sprinkler times. Check what applies to you.
With Groundsman
Section titled “With Groundsman”Groundsman can draw your drip tube on the map and show how much of the bed it wets.
- Turn on Sprinklers in Settings (“List each zone’s sprinkler heads”). On the Zones tab, under Timers, tap the zone’s Answer setup questions (or Edit answers) and pick Drippers when it asks how the zone is watered.
- On the Zones tab, under the zone’s Sprinklers, tap Choose by photo. A drip zone opens on drip, soaker and micro. Pick your drip tube (Pope Drip Eze, Holman and Netafim Techline and Rain Bird XFD are listed).
- Type the metres and tap Add, or tap Draw on map and click along each row, corner by corner. Finish this run starts the next row; Done when you’re finished.
- Groundsman works out the number of drippers and the zone’s flow from the length, and shows each dripper’s wetted circle on the map.
- The zone says about what share of the bed the tube wets. If plants fall outside the wet strips, add a row or move one.
- Use 📏 By distance to place rows by measurement from an edge of the bed.
Soaker and weeper hose can be added the same way. Makers don’t publish a soaker’s flow, so type it in or use the zone’s last metered run.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
