Skip to content

How to water deeply and less often for deeper roots

Water less often but for longer, so each watering wets the soil 100 to 150 mm down, then wait until the top layer has dried before watering again. Roots follow the water, so a lawn trained this way roots deeper, copes better with hot spells and uses less water overall.

A short daily run wets only the top few centimetres. Roots have no reason to go deeper, so the lawn ends up with a shallow mat of roots in the layer that dries fastest. On the first 40-degree day it wilts, even though you watered that morning.

Light, frequent watering also:

  • loses a bigger share to evaporation, because the water sits near the surface in the sun and wind;
  • keeps the surface damp, which suits fungal disease, moss and weeds such as winter grass;
  • encourages thatch.

Deep watering does the opposite. Water sinks below the surface, where it’s out of the sun, and roots grow down to find it.

Aim for about 10 to 20 mm per watering, enough to wet the root zone. How often depends on how much water your soil holds and how fast it’s being used:

  • Midsummer, loam or clay: every 3 or 4 days.
  • Midsummer, sandy soil: every 2 or 3 days (sand holds less).
  • Spring and autumn: every 5 to 7 days.
  • Winter: usually rain alone.

On clay, a deep watering may need splitting into two or three rounds so it soaks in. See how to water clay soil without runoff.

If your lawn is used to daily watering, change gradually over two or three weeks, ideally in spring before the heat:

  1. Go to every second day, with double the run time.
  2. A week later, every third day, with the run time to match.
  3. Then settle on what suits your soil.

Expect the lawn to look a little dull in the afternoon on hot days at first. That’s normal while roots chase the water down. If footprints stay pressed in or the colour goes blue-grey, water sooner.

  • Mow a little higher in summer. Taller grass shades the soil and grows deeper roots.
  • Core aerate compacted areas.
  • Fix water-repellent patches (common on sandy soils near the coast) with a wetting agent.

Groundsman has two methods built for this.

  1. On the Watering tab, press + New program.
  2. Choose Deep and infrequent. Groundsman works out how many days the soil can go between waterings (from your soil, grass and this month’s evaporation) and how much each go should put down, and sets the program to water every few days.
  3. Pick your zones and check the suggested settings.

For something that adjusts itself all year, choose Soil water balance instead. It tracks how much water each zone’s soil has left, waters only when it would dry past the grass’s stress point, and fills it back up. In a hot week it waters more often; in a cool, wet week it may not water at all. You’ll see each zone’s soil water on the Home tab.

Set Soil in Settings first, so the depths and soak times suit your ground. Right amount?, in the Health check on the Watering tab, then shows whether each zone is getting what it needs this month.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au