Skip to content

How much water does a lawn need in Adelaide? (mm per week by season)

An established warm-season lawn in Adelaide (couch, buffalo, kikuyu or zoysia) needs roughly 25 to 35 mm of water a week at the peak of summer, about half that in spring and autumn, and usually nothing from you in winter, when rain covers it. Cool-season lawns such as tall fescue need about a third more. To know how long to run your sprinklers, measure how many mm an hour they put down with a catch-cup test.

Lawn water is measured as a depth, the same way rain is. 1 mm of water over 1 square metre is 1 litre. So 25 mm on a 100 m² lawn is about 2,500 litres.

Using mm lets you compare what the lawn loses, what the rain gives and what your sprinklers put down, all in the same unit.

Where the water goes: evaporation and crop factor

Section titled “Where the water goes: evaporation and crop factor”

A lawn loses water every day through its leaves and from the soil. Weather services estimate this as evaporation (reference evapotranspiration), in mm a day. It depends on heat, sun, wind and humidity.

In Adelaide, that’s roughly:

  • 7 to 8 mm a day in January;
  • 4 to 5 mm a day in October and March;
  • 1.5 mm a day in June.

Grass doesn’t use the full amount. The share it uses is the crop factor:

  • about 0.6 for warm-season grasses (couch, buffalo, kikuyu, zoysia);
  • about 0.8 for cool-season grasses (tall fescue, ryegrass).

So a buffalo lawn in January uses about 7.5 × 0.6 = 4.5 mm a day, or about 30 mm a week. A tall fescue lawn uses about 7.5 × 0.8 = 6 mm a day, or about 40 mm a week.

Then take off useful rain. Adelaide’s summer rain is light and much of it evaporates, so it rarely counts for much. Winter rain usually covers everything.

Rough guides for an established lawn on the Adelaide plains, in full sun, before rain:

Season Warm-season grass Cool-season grass
Summer (Dec to Feb) 25 to 35 mm a week 35 to 45 mm a week
Autumn (Mar to May) 10 to 20 mm, dropping fast 15 to 25 mm
Winter (Jun to Aug) Usually none, rain covers it Usually none, top up in a dry spell
Spring (Sep to Nov) 10 to 20 mm, rising 15 to 25 mm

Adjust for your spot:

  • Shade cuts water use, often by a quarter or more.
  • Hot, windy or north-facing lawns use more.
  • The Adelaide Hills are cooler with more rain, so need less.
  • A lawn kept a little long shades its own soil and loses less.
  • New lawns need more, often, until rooted. See how to water a new lawn.

Your soil changes how you split the week up, not the total. Clay holds more, so fewer, deeper waterings in rounds. Sand holds less, so shorter, more frequent ones. See how often to water your lawn in Adelaide.

Sprinklers vary a lot. A pop-up spray might put down 30 mm an hour; a rotor 10 mm an hour or less. You can’t know your run time without measuring.

  1. Set out 6 or more straight-sided cups or tins, all the same, across the lawn.
  2. Run the zone for a set time, say 15 minutes.
  3. Measure the water depth in each cup with a ruler and take the average.
  4. Work out mm an hour: average depth × 60 ÷ minutes run. For example, 3 mm in 15 minutes is 12 mm an hour.

See how to measure your sprinkler output.

Minutes = mm you want ÷ mm an hour × 60.

Example: a buffalo lawn in January needs about 30 mm a week. Three waterings of 10 mm each, with sprinklers putting down 12 mm an hour, is 10 ÷ 12 × 60 = 50 minutes per watering.

The cups also show evenness. If some cups catch far less than others, the lawn will have dry patches whatever the run time. Fix the heads before adding minutes.

  • The lawn springs back after you walk on it.
  • A screwdriver pushes into the soil without much effort a day after watering.
  • No water runs onto the path while the sprinklers are on.

Grey-green colour, footprints that stay and curling leaves mean it needs more. Soggy ground, mushrooms and moss mean it’s getting too much. See how to tell if your lawn is overwatered.

  1. On Home, under each lawn zone in the Zones card, tap Measure its watering rate and follow the catch-cup test. Groundsman saves each zone’s mm an hour. See catch-cup test.
  2. On the Zones tab under Timers, answer each lawn’s setup questions (Answer setup questions or Edit answers), including its grass and area, so Groundsman knows if it’s warm- or cool-season. See zone settings.
  3. On the Watering tab, press Open on the Health check line to see Right amount?. It compares each zone’s mm for the week with what it needs this month, from Adelaide’s evaporation and rain, your grass and your soil. See right amount?.
  4. Tap Cut to or Raise to to fix a zone, or Set the suggested seasonal adjust when most zones are off in the same direction. These fixes also show under Needs you on the Home tab.
  5. For a lawn that follows the weather day by day, choose Soil water balance when you tap + New program. It waters only when the soil would dry past the lawn’s stress point. See watering methods.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au