How to get stripes in your lawn
Lawn stripes come from a roller bending the grass blades in alternate directions. Blades bent away from you reflect more light and look pale; blades bent towards you look dark. To get them you need a mower with a roller (a rotary mower with a rear roller, or a cylinder mower), a lawn kept a little longer than its lowest height, and straight passes up and back.
What you need
Section titled “What you need”- A roller. The roller is what makes the stripe. A standard four-wheel rotary mower won’t do it. A rotary mower with a rear roller or a cylinder mower will. Some people fit a striping kit or drag a light roller behind.
- A dense, healthy lawn. Stripes show best on a thick, even lawn. Buffalo, kikuyu and couch all stripe well in Adelaide; buffalo’s broad leaf shows them strongly.
- Enough leaf. Very short grass has little to bend. Cut a bit above the bottom of your grass’s range: for example around 35 to 40 mm for buffalo, or 15 to 20 mm for couch.
How to mow stripes
Section titled “How to mow stripes”- Edge first, then mow a border pass or two around the outside. This gives you room to turn.
- Pick a straight line to start, such as along a path or fence. The first stripe sets the rest.
- Mow up and back. At the end of each pass, turn on the border and come back alongside the last stripe, overlapping slightly so there are no gaps.
- Finish with a final border pass to tidy the turning marks.
Keep them looking good
Section titled “Keep them looking good”- Change direction each mow. Go lengthways, then crossways, then diagonally. Mowing the same line every time wears ruts and lays the grass over permanently.
- Mow often. Stripes fade as the grass grows upright again. At the peak of an Adelaide summer that can mean twice a week.
- Keep the blade sharp so tips cut cleanly instead of tearing.
- Mow when it’s dry. Wet grass clumps and the stripes smudge.
- Feed and water well. Thin, hungry or drought-stressed lawns don’t hold a stripe.
For a checkerboard, mow one set of stripes, then mow again at right angles.
With Groundsman
Section titled “With Groundsman”Pick the Striped look in the Mowing plan and Groundsman sets the height and frequency, and puts the striping how-to into each mowing job.
- On the Garden tab, open Mowing plan and choose Striped as the look.
- Check Cut at. Groundsman suggests a height a little above the middle of each lawn’s range and warns if it doesn’t suit the grass.
- Under What you’ve got, tick Rotary mower with a rear roller or a cylinder mower. If you haven’t got a roller, the plan reminds you that stripes come from one.
- Tap Put it on my jobs (or Update my mowing jobs). Striped lawns are mown more often at the peak of summer, about twice a week, and the job’s notes tell you to alternate directions and change the pattern each time.
- Before a party or Christmas, add it under Lawn dates and tick Mow & edge the day before, so the stripes are fresh on the day.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
