How to use a soil moisture sensor to save water
A soil moisture sensor measures how wet the soil is around the roots, so you water only when the garden needs it. Bury it in the root zone of a typical spot, watch its readings for a week or two, then set the moisture level at which watering should be skipped.
Why measure the soil
Section titled “Why measure the soil”Schedules and forecasts are guesses, while a sensor measures the soil itself. It catches things a timer can’t: a shady corner that stays wet, a storm that missed your suburb, a lawn on heavy clay that holds water for days after rain. In spring and autumn, when Adelaide weather swings, it can save a lot of runs.
Where to put it
Section titled “Where to put it”- In a representative spot. Not the soggy low corner or the dry strip by the fence. Pick somewhere that gets average sun and average water.
- In the root zone. For a lawn, about 75 to 100 mm down. For a garden bed, 150 to 200 mm, near the plants’ roots.
- Within the zone it controls, where its sprinklers or drippers reach it. For drip, within 100 to 200 mm of a dripper.
- Firm soil around it, with no air gaps. Gaps give false dry readings.
- Away from mower wheels, edges and where the dog digs.
One sensor per zone is ideal. If you have one, put it in the zone that matters most, usually the main lawn.
Reading the numbers
Section titled “Reading the numbers”Most consumer sensors show moisture as a percentage. The number isn’t the same across soils: 30% in sand can be wet, while 30% in clay can be dry. So learn your own soil:
- Water the zone deeply and note the reading an hour later. That’s “full”.
- Watch it fall over the next days. When the grass starts to look dull or footprints stay pressed in, note the reading. That’s “time to water”.
- Set the skip level somewhere between the two, closer to full. Watering is skipped above it.
Readings drift a little through the year as the soil temperature changes. Recheck in spring and autumn.
Battery-powered sensors need new batteries every year or so. A flat sensor gives no readings, and then watering should carry on as normal.
With Groundsman
Section titled “With Groundsman”Groundsman works with Holman WXMS and other Tuya soil sensors.
- Add the sensor with Add a timer or sensor on the Zones tab (it goes through the Groundsman cloud); see Add a timer or sensor.
- On the Zones tab, open the zone’s settings and pick the sensor.
- Set the moisture % to skip at. Scheduled watering for that zone is skipped while the soil is at least that wet.
- Watch the Soil sensors card on the Zones tab for a week to see how the readings rise and fall, and adjust the skip % if needed.
Manual runs always water, whatever the sensor says. Readings more than 12 hours old are ignored, so a flat battery or lost signal means the zone waters as scheduled rather than drying out. Skipped runs show in Run history as skipped for wet soil, and the Monthly report counts them.
A sensor works alongside rain skips, Seasonal adjust and the Soil water balance method. The sensor only ever skips a run: it never adds water.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
