How to water your garden from a rainwater tank
A rainwater tank fills over winter and has to last through a dry summer, so use it where it counts most: garden beds, vegetables, fruit trees and pots, on drippers. A lawn can empty a typical home tank in a few waterings. Most tank setups need a pressure pump to run sprinklers or tap timers well.
How far tank water goes
Section titled “How far tank water goes”1 mm of water on 1 m² is 1 litre. So:
- one 10 mm watering of a 100 m² lawn uses about 1,000 litres;
- a summer’s lawn watering (about 25 to 30 mm a week from December to February) on that lawn is around 35,000 litres;
- a 5,000 litre tank covers about five lawn waterings, or many weeks of drip on beds.
A roof catches about 1 litre per m² of roof for every millimetre of rain (a little less after first-flush and gutter losses). Adelaide’s summer rain is light and unreliable, so a full tank in November is often most of what you’ll get until autumn.
Where to use it
Section titled “Where to use it”Give tank water to the plants that most need it and use it efficiently:
- Vegetables, herbs and fruit trees, especially citrus, which hates drying out in summer.
- Pots and new plantings, which don’t cope with skipped waterings.
- Garden beds on drip, where almost nothing is lost to evaporation.
- Lawns, if you have a big tank or a small lawn. Otherwise consider a mains-and-tank switch so the lawn uses mains when the tank runs low.
Rainwater is soft and slightly acidic, and plants generally love it.
Pressure and pumps
Section titled “Pressure and pumps”Tap timers and sprinklers need pressure. A tank tap relying on gravity gives very little: enough for drippers on a short run, but not for pop-up sprinklers.
- A pressure pump with an automatic pressure switch starts when a tap opens and stops when it closes, so tap timers work as they would on mains.
- Some pumps have mains switchover that changes to mains water when the tank is low.
- Fit a filter after the pump. Tank water carries sediment that blocks drippers and timer valves.
- Check the pump can supply the zones you run at once. Two big sprinkler zones together may be too much.
The rules
Section titled “The rules”SA Water’s Water Wise Measures apply to mains water. Tank water isn’t covered by the sprinkler hours, though watering early or late is still better because less evaporates. If your system switches between tank and mains, follow the rules when it could be on mains.
With Groundsman
Section titled “With Groundsman”Groundsman’s tap timers work on a tank tap like any other, as long as a pressure pump keeps the pressure up.
- If every zone runs on tank, bore or recycled water, go to Settings, find Watering rules and choose “Tank, bore or recycled water (mains rules don’t apply)”. Programs are no longer flagged for mains watering hours.
- In each bed zone’s setup questions (Zones > Timers > Answer setup questions or Edit answers), pick Drippers for how it’s watered, so run times suit drip.
- On the Watering tab, press Open on the Health check line and set Running together to One at a time if your pump struggles with two.
- Use rain skips in Settings so a wet week doesn’t use tank water you might need later.
- Watch Water used on the Home tab. Its Projected water use shows the next 7 and 30 days, a good guide to how long a tank will last. A flow meter on the timer gives exact litres.
If the pump fails or the tank runs dry, a zone with a flow meter shows a “No water came out” alert, and the cloud emails it to you.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
