How to mix a lawn spray
To mix a lawn spray, work out your lawn’s area, multiply by the label rate (usually given per 100 m²), and dilute it in the water volume the label gives for that area. Then split it into as many sprayer fills as your sprayer needs. Mixing more than one product (a tank mix) works the same way, product by product, as long as each label allows it.
The maths
Section titled “The maths”Labels give two numbers: how much product per 100 m², and how much water to spray it in per 100 m².
Example: a lawn of 150 m², a product at 50 mL per 100 m² in 5 L of water per 100 m².
- Product: 150 ÷ 100 × 50 = 75 mL
- Water: 150 ÷ 100 × 5 = 7.5 L
- With a 5 L sprayer, that’s two fills: about 37 mL of product in 3.75 L of water each.
Splitting the product evenly between fills keeps the dose right across the whole lawn.
Calibrate your walking pace
Section titled “Calibrate your walking pace”The water volume only works if you put it out evenly. Fill your sprayer with plain water, mark out 10 m² and spray it at a steady walking pace. Measure how much you used. If you put out half the expected amount, slow down or overlap more; if you ran dry early, walk faster. A marker dye helps you see where you’ve been.
Mixing
Section titled “Mixing”- Read every label first. Check the rate, the water volume, whether it’s safe on your grass, and whether it can be mixed with anything else.
- Wear what the label says: usually gloves and eye protection at least.
- Half-fill the sprayer with clean water.
- Measure each product accurately with a measuring cup or syringe kept for garden chemicals.
- Add products one at a time, swirling between each, in the order the labels give. Then top up to the full volume.
- Use it the same day. Don’t store mixed spray.
When and how to spray
Section titled “When and how to spray”- Calm, mild days. No wind (drift kills garden plants) and under about 30°C. Many products stop working or scorch in heat.
- No rain or watering for a day after a weed spray or liquid feed, unless the label says to water it in.
- Mow a couple of days before a weed spray, not straight after, so there’s leaf to absorb it.
- Rinse the sprayer three times afterwards and spray the rinse water back over the lawn.
- Keep children and pets off until it’s dry.
Always follow the label rate and safety directions. The label is the legal instruction for that product.
With Groundsman
Section titled “With Groundsman”Groundsman does the maths for each job using your lawn areas and sprayer size.
- Set your sprayer in Settings under Products and plan > Sprayer size (anything from 0.5 to 100 L).
- On a spray job (from the Today checklist on Home, or the Garden tab), tap How to mix and apply. It shows each product’s rate Per 100 m² and the amount for Your lawn, the spray water volume, how many sprayer fills it takes, and the before-and-after steps. Change Your sprayer there with the 2, 5, 8 or 15 L buttons or Other. See how to mix and apply.
- For a tank mix (a job with several products), the job opens into a line per product with its amount. Tick each as it goes in, or skip one this time; a skipped product comes back in a week. See tank mixes.
- Tap Done. Sprays that need dry leaves hold scheduled watering on those zones for the hours the job sets. See after-care.
- Answer How much did you use? and My products takes it off your stock.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
