How to water in fertiliser
Water granular fertiliser in straight after spreading it, with about 10 mm of water. That washes the granules off the leaves and into the soil, where the roots can use them, and stops them scorching the grass. Liquid feeds and weed sprays are the opposite: most need the leaves to stay dry for a day.
Why it matters
Section titled “Why it matters”- Granules on leaves can burn. Fertiliser salts sitting on damp leaf in the sun draw moisture out and leave brown speckles or stripes.
- Nutrients need moisture to move. Until it’s watered in, the feed isn’t reaching the roots.
- Pre-emergent has to reach the soil to form its barrier, so it’s watered in too.
- Wetting agents need water to carry them into the soil.
How much is 10 mm?
Section titled “How much is 10 mm?”Ten millimetres is the depth of water that would sit on a flat surface. How long your sprinklers take to put that down depends on their rate:
| Sprinkler type | Typical rate | Time for 10 mm |
|---|---|---|
| Pop-up sprays | about 10 mm an hour | about 60 minutes |
| Rotary nozzles or rotors | often 8 to 15 mm an hour | 40 to 75 minutes |
These are rough. The only way to know your own is a catch-cup test: set out straight-sided cups, run the zone for a set time and measure what lands.
On heavy clay, don’t put it all on at once. Run it in two or three shorter rounds with a break between, so the water soaks in instead of running down the driveway, carrying your fertiliser with it.
Products that should stay dry
Section titled “Products that should stay dry”- Liquid fertilisers and green-ups are taken in through the leaf. Keep them dry for about 24 hours, unless the label says otherwise.
- Selective weed sprays need time on the leaf to be absorbed. Rain or sprinklers too soon washes them off.
- Fungicides usually want the leaves dry for a while too.
Always follow the label. It tells you whether to water in, how much, and how long to keep dry.
Can rain do it?
Section titled “Can rain do it?”Steady light rain after spreading is ideal. Heavy rain isn’t: it can wash granules off the lawn and into the stormwater. If a downpour is forecast, wait until after it. Don’t count on a forecast shower to water in for you; if it doesn’t come, water it in yourself the same day.
With Groundsman
Section titled “With Groundsman”Groundsman waters in for you when you mark the job done.
- Do a catch-cup test on each lawn zone (on the Home tab, Measure its watering rate under each zone). This gives the zone’s real rate in mm an hour, so Groundsman knows how long 10 mm takes. Without one it uses a typical rate (10 mm an hour for sprinklers). See catch-cup test.
- Spread the product. The job’s guide on the Today checklist on Home tells you how much water it needs (“water it in: 10 mm”) and how many minutes that is per zone.
- Tap Done. Groundsman asks to confirm, then runs the watering-in on the job’s zones straight away.
- For a liquid feed or spray, Done holds scheduled watering on those zones instead, for the hours the job sets, so a program doesn’t wash it off overnight.
- To change what happens, edit the job: After-care when marked done has Water in for (minutes per zone) and Hold scheduled watering for (hours). See after-care.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
