Skip to content

How to add another tap timer to your garden watering

Adding a tap timer gives a part of the garden its own watering, with its own days, minutes and rain skips. With Groundsman you pair it from the app in a couple of minutes and draw its zone on the map. An installer can do it for you if the tap is a long way from the hub or you need a second hub.

A zone should water one kind of planting with one kind of sprinkler. Split it when:

  • A lawn and a garden bed share a timer. Lawn needs about twice the water a mulched bed does, so one of them is always wrong.
  • Sprays and drippers share a line. Pop-up sprays put down many times more water an hour than drippers. Run together, the drip plants go thirsty or the lawn floods.
  • Sun and shade share a zone. A west-facing strip in an Adelaide summer dries out far faster than a lawn under a gum.
  • There’s a new bed or new plants. New plantings need short, frequent watering for their first summer, then much less. A zone of their own lets you taper it off without touching the rest.
  • Pots and veggies. These need water most days in summer, when the lawn may only need it twice a week.
  • On a tap. Each timer screws onto a garden tap. A two- or four-outlet timer turns one tap into two or four zones, but the outlets take turns, because they share the tap’s flow.
  • In range of the timer hub. Holman hubs reach up to about 50 m in the open. Brick walls, sheds, water tanks and metal fences cut that a lot.
  • On a hub with room. One Holman hub takes 4 timers. A fifth timer needs a second hub.

Adding a timer yourself needs your controller connected to the Groundsman cloud. If the button below isn’t there, see add a timer or sensor.

  1. Fit the new timer on its tap and put the batteries in, but keep it near the hub while pairing.
  2. In the app, open the Zones tab and press Add a timer or sensor.
  3. Pick the hub with room if you have more than one, and press Start pairing.
  4. Hold the timer’s pairing button until its light flashes. It appears in the app by itself.
  5. Press Done, then rename the new zone (“Veggie patch”) and press Answer setup questions on its card under Timers to say what it waters, how it’s watered and which tap it’s on. See zone settings.
  6. Draw the zone’s shape on the map. See draw zones.
  7. Add it to a program on the Watering tab, or press + New program for a schedule of its own.
  8. Test it from Test timers on the Home tab.
  • The new tap is out of the hub’s range and needs a hub moved or a second hub.
  • You’d like new sprinkler lines or drip run to it at the same time.
  • Your controller isn’t connected to the Groundsman cloud.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au