Skip to content

How to water garden beds with drippers and drip tube

Drippers water slowly and right at the roots, so they run for much longer than sprinklers: often 30 to 60 minutes a go, two or three times a week for established plants in an Adelaide summer. Under mulch, almost nothing is lost to wind or evaporation.

Sprays in a garden bed wet leaves, paths and the gaps between plants, and much of it evaporates in a hot north wind. Drip puts water where roots are, under the mulch, with no overspray. Dry leaves also mean less black spot and mildew on roses and other disease-prone plants.

Under SA Water’s Water Wise Measures, drippers can be used at any time of day, while sprinklers are limited to before 10am or after 5pm. That makes drip handy for beds that need a top-up on a hot afternoon.

Drip is measured in litres an hour per dripper. Common sizes are 2 and 4 litres an hour, and inline drip tube usually has a dripper every 300 mm at about 2 litres an hour.

A useful rule is to wet the root zone, then let it partly dry:

Plants Summer Spring and autumn
Established shrubs, roses, hedges 45 to 60 min, 2 to 3 times a week 45 to 60 min, once a week
Natives and succulents (established) 60 min, every 7 to 10 days rain, mostly
Vegetables and annuals 20 to 30 min, every day or two 20 to 30 min, 2 to 3 times a week
New plantings see how to water new plants

These are starting points. Dig down beside a plant a couple of hours after a run: the soil should be moist 200 to 300 mm down for shrubs. In sandy soil water goes straight down in a narrow column, so drippers need to be closer together. In clay it spreads sideways, so they can be further apart.

  • Put drippers or drip tube over the root zone, not against the trunk. As plants grow, add drippers towards the drip line.
  • Cover drip tube with 50 to 75 mm of mulch to stop evaporation and protect it from the sun.
  • Fit a filter at the tap and flush the line once or twice a year. Blocked drippers are the most common fault.
  • Check for split tube or popped fittings each spring, especially after digging.
  1. On the Zones tab, under Timers, tap Answer setup questions (or Edit answers) on the bed’s zone. Answer Garden beds, hedges or pots, then pick Drippers (or Weeper or soaker hose) for how it’s watered. For drippers, it asks how many there are and how much each gives: usually 2, 4 or 8 litres an hour, often printed on them. If the timer has a flow meter you can skip that, as it learns the zone’s flow by itself.
  2. If you’ve turned on Sprinklers in Settings, add Drip tube by the metre or draw it on the map, so Groundsman knows how much water the zone puts out (drip tube and weepers).
  3. On the Watering tab, press + New program, choose As set or Deep and infrequent, pick the bed zones and check the suggested minutes.
  4. Right amount? doesn’t check drip zones in mm, because drippers water plants rather than an area. Go by how the plants look and how damp the soil is a finger deep, and watch the zone’s litres in Water used on Home.

Groundsman leaves drip zones out of cycle and soak, because they’re too slow to run off. If Watering rules is set From my address, drip zones aren’t flagged for watering in the restricted hours, since the rules allow them. A flow meter on the timer will show if a dripper line’s flow drops (a blocked filter) or jumps (a split tube) through flow alerts.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au