Skip to content

How to water new plants until they're established

Water new plants deeply on the day you plant them, then every day or two for the first couple of weeks, then gradually less often over the next two or three months. A new plant’s roots are still inside the original potting mix, which dries out much faster than the soil around it.

A plant from a pot arrives with a root ball of light potting mix. Until roots grow out into the garden soil, it can only drink from that root ball, and in an Adelaide summer a root ball can dry out in a day even when the surrounding soil is damp. Most new plants that die in their first summer die of thirst, not disease.

  • Water the plant in its pot an hour before planting. A dry root ball repels water.
  • Dig the hole twice as wide as the pot and no deeper. Rough up the sides in clay so roots can break through.
  • Fill around it with the soil you dug out, firm it, and shape a low ring of soil around the plant to hold water over the root ball.
  • Soak it with a full bucket (about 10 litres for a shrub, more for a tree) even if the soil is wet.
  • Mulch 50 to 75 mm deep, keeping it a hand’s width back from the stem.
Time since planting How often Notes
Week 1 to 2 Every day in summer, every 2 to 3 days in cooler months Keep the root ball moist, not soggy
Week 3 to 6 Every 2 to 3 days Longer each time, to draw roots outward
Month 2 to 3 Twice a week Then fold into the bed’s normal watering
First summer An extra deep watering before hot spells Trees may need this through two summers

Natives and succulents establish faster on less water and rot if kept wet. Water them in well, then once or twice a week, and stop sooner.

In Adelaide, autumn (March to May) is the best time to plant most shrubs, trees and natives. The soil is still warm, so roots grow, and winter rain does most of the watering. By summer the plant has had months to settle. Spring planting works too but needs more care through the first summer. Avoid planting in the heat of December to February if you can.

Drippers are the most reliable way to keep a new plant going, because they water slowly right on the root ball. Put one or two drippers within the planting ring, not out at the edge of the bed. Move them outward or add more as the plant grows. A hand-held hose with a trigger nozzle is fine for a few plants and is allowed at any time under SA Water’s rules.

  1. On the Garden tab, add the plant from the Plants card (pick from the list or Pick from pictures instead) and place it on the map. Add care jobs adds its yearly care, such as feeding and pruning, to the Garden tab.
  2. To water a bed of new plants more often for a while, go to the Watering tab, press + New program, choose As set, pick the bed’s zone and set it to water daily or every 2 days with a short run.
  3. Every couple of weeks, open the program and lengthen the minutes while lowering the days, following the taper above.
  4. When the plants are settled, switch that program off with its on/off switch and let the bed’s usual program carry on.

For a quick top-up on a hot afternoon, use the zone’s 10, 20 or 30 minute buttons on the Home tab. Manual runs always water as set, whatever the rain settings.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au