Skip to content

How to fix water-repellent soil in your lawn

Water-repellent (hydrophobic) soil sheds water instead of soaking it up, so you get dry, brown patches even when the sprinklers run. It’s common in the sandy soils of Adelaide’s coastal suburbs. The fix is a wetting agent applied in spring and repeated through summer, watered in, plus coring and watering in shorter rounds so water has time to get in.

Sand grains get coated with waxy residues from decaying roots, thatch and organic matter. Once the soil dries out, those coatings repel water the way a raincoat does. The drier it gets, the worse it becomes, which is why the problem shows up in late spring and summer and often fixes itself after a wet winter.

It’s most common on:

  • sandy coastal soils, such as the western and southern seaside suburbs;
  • lawns with a lot of thatch;
  • mounds and slopes, where water runs off before it soaks in;
  • spots near trees, where roots compete and the soil dries faster.
  • Water beads, runs off or pools on the surface.
  • Irregular dry patches that don’t green up after watering.
  • Soil that’s dry a few centimetres down after you’ve watered.
  • A lawn that greens up after steady rain but not after sprinklers.

Take a small sample of dry soil from a patch, put a few drops of water on it and watch. If the drops sit on top as beads for more than a few seconds before soaking in, the soil is water-repellent.

A soil wetting agent is a surfactant: it helps water break through the waxy coating and spread through the soil. It comes as a liquid (applied with a hose-on or pressure sprayer) or as granules.

  • Start in spring (September or October), before the soil dries out completely.
  • Repeat through summer, typically every 6 to 12 weeks depending on the product.
  • Water it in straight after, about 10 mm, so it carries down into the root zone.

Follow the label rate and safety directions.

Hollow-tine coring opens channels for water to get past the repellent top layer. Do it in spring, then apply wetting agent so it runs into the holes.

A long single run on repellent soil mostly runs off. Split it into two or three shorter rounds with a soak between. Each round wets the surface a bit more, and the next one soaks in better.

Top dressing with a soil mix that includes some organic matter and clay helps sandy soil hold water. Mowing a little higher and keeping thatch down both help too.

  1. In Settings, set Soil to sandy. Cycle and soak uses it to size each round to what the soil takes in.
  2. On the Watering tab, press Open on the Health check line and check Right amount?. Where a program puts down more at once than the soil takes in, it offers Split into rounds (cycle and soak), and the same fix shows under Needs you on the Home tab. Or create a program with + New program and choose Cycle and soak. See watering methods.
  3. On the Garden tab, use Add a job > Wetting agent. It’s in season September to March, every 3 months, with watering-in after. Shorten the repeat if your product’s label says so. Many of the supplier’s Guided plans include a wetting agent step too.
  4. When it’s due, tap How to mix and apply for the amount for your lawn, then Done to water it in.
  5. A soil moisture sensor in the worst zone shows how wet the soil really is. See soil sensors.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au