Soil sensors
A soil moisture sensor tells Groundsman how wet the ground is. You set a moisture level for a zone, and when the soil is at least that wet, its scheduled watering is skipped.
Which sensors work
Section titled “Which sensors work”- The Holman WXMS, which pairs to a Holman tap timer and reports through it.
- Other Tuya soil sensors, which pair to the timer hub or join your Wi-Fi.
Sensors are usually added with the timers at setup. To add one later, see Add a timer or sensor.
See the readings
Section titled “See the readings”- Zones tab > Soil sensors: each sensor’s moisture, a small chart of recent readings, temperature, battery and when it was last read. You can rename a sensor here.
- Home: each zone with a sensor shows “Soil” and its moisture %.
Link a sensor to a zone and set the level
Section titled “Link a sensor to a zone and set the level”- Open the Zones tab and find the zone under Timers.
- In the soil sensor list, pick the sensor. A timer with its own sensor shows Sensor on this timer. Choose No soil sensor to stop using one.
- Next to Skip watering at, type a moisture %, for example 35. Leave it empty to show readings without skipping.
From then on, when the reading is at that level or wetter, the zone’s scheduled watering is skipped. The run history records it as skipped for wet soil.
Good to know
Section titled “Good to know”- Manual runs always water, whatever the sensor says.
- Readings older than 12 hours are ignored, so a flat battery or lost sensor doesn’t stop watering.
- The sensor only affects its own zone. Other zones water as normal.
Choosing a level
Section titled “Choosing a level”There’s no single right number: it depends on the sensor, where it sits and your soil. A practical way to find yours:
- Note the reading a day after a good soak, when the lawn looks well watered.
- Note it again when the lawn first starts to look thirsty.
- Set Skip watering at a little below the first figure.
Place the sensor in the root zone of a typical spot, not under a sprinkler head, a tree or the edge of a path.
- Clay holds water longer than sand, so readings fall more slowly on clay.
- A soil sensor pairs well with rain skipping. See Rain and weather.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
