How to prune roses in Adelaide
Prune roses in Adelaide in July, while they’re dormant. Cut bush roses back by about half to an outward-facing bud, remove dead, crossing and spindly canes, and open the centre into a vase shape. Then spray the bare canes with lime sulphur in August, before the new leaves come.

A bush rose in flower. Photo: Salicyna, Wikimedia Commons, CC BY-SA 4.0.
When to prune
Section titled “When to prune”Mid-July suits most of Adelaide. Prune too early and a warm spell can push soft growth that a late frost damages; prune too late and you cut off the new shoots. In the colder Adelaide Hills, late July into early August is safer.
What you need
Section titled “What you need”- Sharp bypass secateurs, loppers for thick canes and a pruning saw for old wood.
- Thick gloves.
- Methylated spirits or a disinfectant to wipe blades between plants, so you don’t spread disease.
How to prune a bush rose
Section titled “How to prune a bush rose”- Take out the dead wood. Cut dead, brown or black canes back to the base or to healthy green wood.
- Remove the weak and crossing canes. Anything thinner than a pencil, and any canes rubbing against each other or growing into the middle.
- Open the centre. Aim for three to six strong canes spaced like a vase, so air moves through. Good air flow is the best defence against black spot.
- Cut back by about half. Cut each remaining cane about 5 mm above an outward-facing bud, sloping away from the bud so water runs off.
- Clean up. Rake up and bin old leaves and prunings. Don’t compost them: they carry black spot spores.
Other kinds of roses
Section titled “Other kinds of roses”- Iceberg roses: a lighter prune. Cut back by about a third and take out dead and woody canes.
- Climbing roses: keep the long main canes and tie them as close to horizontal as you can; horizontal canes flower more. Shorten last year’s side shoots to two or three buds and remove a few of the oldest canes.
- Standard roses: prune the head into a balanced ball, cutting to outward buds about 15 to 20 cm from the graft at the top of the stem. Check the stake and ties in June so they don’t cut into the trunk.
After pruning: the rest of the rose year
Section titled “After pruning: the rest of the rose year”- August: spray lime sulphur over the bare canes to knock back scale and fungal spores. Not on new leaves.
- September: feed with rose food as growth starts, then again in December after the first flush and in February for autumn flowers.
- October: top up mulch to 5 to 7 cm, kept a hand’s width off the stems.
- October to April: deadhead by cutting spent blooms back to the first full five-leaf set.
- Spring and summer: pull suckers from below the graft (they have smaller, duller leaves). Tear them off at the root rather than cutting them.
- October to March: check for black spot and aphids. Pick off spotted leaves; hose off aphids. Spray only if it’s spreading.
Water roses deeply at the base, ideally with drippers. Wet leaves in warm weather spread black spot.
With Groundsman
Section titled “With Groundsman”Groundsman times all of this for each rose on your map.
- On the Garden tab, open the Plants card and pick your rose from the Roses group: bush, climbing, standard, Iceberg, French or musk. Pick from pictures instead helps if you’re unsure.
- Tap Place on the map, click each rose, then tap Done.
- Tap Add care jobs under In your garden.
- The jobs appear on the Garden tab, and on the Today checklist on Home when due, starting with Winter prune roses in July. Each job carries the notes above.
- When you tick off the lime sulphur spray, use the after-care to hold scheduled watering for a few hours so it isn’t washed off.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
