Skip to content

How long to run your sprinklers for the right amount of water

Run each zone long enough to put down about 10 mm of water, which wets a lawn’s root zone in most soils. How many minutes that takes depends on your sprinklers: anywhere from about 15 minutes for fast pop-up sprays to an hour or more for slow rotors and drip.

“Twenty minutes” means very different things on different sprinklers. Fixed pop-up spray heads can put down 30 to 40 mm an hour or more. Rotating heads and many micro-sprays are much slower, often 10 to 15 mm an hour. Drippers in a garden bed are slower again.

So start from depth:

  • Lawns: about 10 mm a go in summer. Two or three goes a week is roughly 25 to 30 mm, which is what an established warm-season lawn needs in an Adelaide summer.
  • Garden beds with sprays: about 10 to 15 mm a go, less often than the lawn once plants are established.
  • Sandy soil: smaller goes (6 to 8 mm), more often, because it holds less.
  • Clay: larger goes are fine, but split them into rounds so water soaks in instead of running off.

Then work out minutes:

minutes = depth in mm ÷ sprinkler rate in mm an hour × 60

For 10 mm from a sprinkler that does 12 mm an hour: 10 ÷ 12 × 60 = 50 minutes.

The only reliable way is to measure it. Put five to ten straight-sided tins (tuna tins work well) across the zone, run it for 15 or 20 minutes and measure the depth in each with a ruler. Multiply the average depth by 60 and divide by the minutes to get mm an hour. The catch-cup test article goes through it.

The test also shows how even the zone is. If some tins catch half what others do, fix the heads before you lengthen the run time, or you’ll overwater most of the lawn to reach the dry spots.

A day after watering, push a long screwdriver into the lawn. It should slide in about 100 to 150 mm. If it stops at 50 mm, the water isn’t going deep enough. If water pools or runs onto the path partway through a run, the run is too long for one go: split it.

Adjust through the year. A run time that suits January is about double what you need in April.

Groundsman sets run times in millimetres and turns them into minutes for each zone.

  1. On the Zones tab under Timers, press Answer setup questions (or Edit answers) on each zone. Say how it’s watered (Sprinklers, Micro-sprays, Drippers or Weeper or soaker hose) and, for sprinklers and micro-sprays, the area it waters. Until you measure, Groundsman uses a typical rate: 10 mm an hour for sprinklers and 15 for micro-sprays. Drip zones have no mm an hour; Groundsman counts their water in litres, from the flow meter or from the number of drippers and what each gives.
  2. On the Home tab, under a sprinkler or micro-spray zone, press Measure its watering rate and follow the catch-cup test. The measured rate replaces the typical one.
  3. On the Watering tab, press + New program, choose a method and zones, and check the suggested minutes. They’re worked out from what each zone needs this month and its rate.
  4. On the Watering tab, press Open on the Health check line and look at Right amount?. If a zone is getting much more or less than it needs this month, it offers Cut to or Raise to. The same fix shows under Needs you on the Home tab.

If you’ve listed each zone’s heads in Settings under Sprinklers, Groundsman can also work out the rate from the makers’ charts and check it against the flow meter.

Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au