How to measure your sprinkler output with a catch-cup test
Set straight-sided tins across a lawn zone, run the sprinklers for 15 or 20 minutes, and measure how deep the water is in each. The average tells you the zone’s rate in millimetres an hour, and the difference between the driest tins and the rest tells you how evenly it waters.
Why it’s worth 30 minutes
Section titled “Why it’s worth 30 minutes”Two numbers decide whether your lawn gets the right water: how fast the sprinklers put it down, and how evenly. Most people know neither. Pop-up sprays, rotors and micro-sprays vary several-fold in rate, so “20 minutes” can mean 4 mm or 15 mm. And a zone with a blocked nozzle or a head knocked crooked leaves dry patches that tempt you to water everything longer.
A catch-cup test answers both. Do it when you set up a zone, after changing nozzles, and whenever a dry patch appears.
What you need
Section titled “What you need”- 6 to 12 identical straight-sided containers. Tuna or cat-food tins are ideal; a tuna tin is about 85 mm across.
- A ruler with millimetres, or a measuring jug.
- A timer.
How to do it
Section titled “How to do it”- Mow the lawn first so the tins sit level.
- Spread the tins across the whole zone in a rough grid: some near the heads, some midway between them, some at the edges. Keep them out of the path of a single head’s stream.
- Run the zone for 15 or 20 minutes, on a still morning at your normal watering time.
- Measure the depth in each tin with a ruler. Or tip each into a measuring jug and note the millilitres.
Work out the rate
Section titled “Work out the rate”Average the depths, then:
mm an hour = average depth in mm × 60 ÷ minutes run
If the tins averaged 4 mm in 20 minutes, the zone puts down 12 mm an hour.
Work out the evenness
Section titled “Work out the evenness”Take the driest quarter of the tins and average them. Divide by the overall average. Above about 75% is good for home sprinklers. Below about 60% is patchy: fix the heads before changing run times.
Fixing a patchy zone
Section titled “Fixing a patchy zone”- Clean nozzles and filters. Grit is the most common cause.
- Straighten and raise heads that have sunk or tilted into the grass.
- Check the arc and throw. Heads should reach the next head (“head-to-head” coverage).
- Don’t mix types on one zone. Sprays and rotors put down water at very different rates.
- Check pressure. Too many heads on one tap gives weak, short throws.
With Groundsman
Section titled “With Groundsman”Groundsman walks you through the test and uses the result for every run time and water estimate.
- On the Home tab, under the zone, press Measure its watering rate. Drip zones don’t have the test.
- Set out your cups, choose how long to run (10, 15, 20 or 30 minutes) and press Start the test run. The app counts it down; you can close it and come back.
- When it stops, enter what each cup caught: with a ruler in mm, or with a measuring jug in mL plus the width of the cups’ opening.
- Press Work out the rate. Groundsman shows the zone’s mm an hour and its evenness.
The measured rate replaces the typical figure for that zone, so new programs, the New lawn method and water-use estimates all use it. If you’ve placed sprinkler heads on the map (Settings > Sprinklers), Groundsman can also show dry spots and suggest better nozzles, arcs or throw.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
