How to stop sprinklers watering the path
Sprinklers that hit the path usually need one of three things: the arc turned or narrowed, the throw shortened, or a different nozzle pattern for that spot. Most pop-up spray heads can be adjusted in a few minutes with the right tool, and water that lands on paving is wasted and runs off into the stormwater.
Why it happens
Section titled “Why it happens”- The head has been turned. Mowers, kids and dogs knock heads around. A quarter or half head facing the wrong way soaks the path.
- The arc is too wide. An adjustable nozzle set to 200° where 180° would do throws past the edge.
- The throw is too long. A 4 m nozzle on a 3 m strip of lawn will always reach the fence.
- The wrong pattern. Narrow strips beside driveways suit strip nozzles (side, end or centre strip), not round patterns.
- Wind and pressure. High pressure turns the spray into a fine mist that drifts. Adelaide’s afternoon sea breeze carries it further.
How to adjust a spray head
Section titled “How to adjust a spray head”- Turn the zone on so you can see the pattern.
- Turn it: with the head popped up, hold the riser and twist the whole stem so the edge of the spray lines up with the edge of the lawn. On many heads you can do this without tools.
- Set the arc: on adjustable nozzles, turn the top collar to widen or narrow the spray.
- Shorten the throw: turn the radius screw on top clockwise, usually with a small flat screwdriver. Most nozzles can come in by about a quarter of their throw before the spray breaks up. Beyond that, fit a shorter nozzle instead.
- Check the next heads still overlap. Shortening one head can open a dry gap.
For gear-driven rotors, the arc and radius are set with the maker’s key or a screwdriver; the maker’s instructions show which slot does what.
Other ways to keep paths dry
Section titled “Other ways to keep paths dry”- Water early: mornings are usually calmer, and SA Water suggests watering before 9am or after 6pm. Less wind means less drift.
- Use rotary nozzles: multi-stream rotating nozzles throw heavier droplets that drift less than fine sprays, and their lower rate suits clay soil.
- Fix the pressure: heads that mist badly may need a pressure-regulating body.
- Swap sprays for drip on narrow beds and strips under about a metre wide. Drip puts every drop at the roots.
With Groundsman
Section titled “With Groundsman”Groundsman can show where each head’s water lands on your map, so you can fix the worst ones first.
- In Settings, turn on Sprinklers (“List each zone’s sprinkler heads”).
- On the Zones tab, add each zone’s heads from the list or with Choose by photo, then tap Place on map and click where each head is. The map needs its scale set first.
- Under the zone, the coverage line says how much of its water lands on no lawn or bed, and how much lands on the zones next door.
- Click a head on the map. Drag the yellow grip to turn it, the white grips to change its arc (within what that nozzle allows) and the blue grip to shorten its throw, as the radius screw does.
- Or tap Suggest better settings. It tries other nozzles that fit each head’s body, arcs, directions and throws, and shows what to change on each numbered head. Use these applies them (undoable).
- Each placed head is listed with its nozzle, arc, direction and radius screw setting, so you can take the list outside and set the real heads to match.
Related
Section titled “Related”Groundsman · smart watering and lawn care for Adelaide homes ·hello@groundsman.au
